HyperX FURY 4GB
HyperX HX318C10F/4 is a 512M x 64-bit (4GB) DDR3-1866 CL10 SDRAM (Synchronous DRAM) 1Rx8 memory module, based on eight 512M x 8-bit DDR3 FBGA components. This module has been tested to run at DDR3-1866 at a low latency timing of 10-11-10 at 1.5V.
•JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
•VDDQ = 1.5V (1.425V ~ 1.575V)
•933MHz fCK for 1866Mb/sec/pin
•8 independent internal bank
•Programmable CAS Latency: 13, 11, 10, 9, 8, 7, 6
•Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
•Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or MRS]
•Bi-directional Differential Data Strobe
•Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
•On Die Termination using ODT pin
•Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C
•Height 1.291” (32.80mm) w/heatsink, single sided component.
CL (IDD): 10 cycles
Row Cycle Time: 44.75ns(min.)
Refresh to Active/Refresh Command Time: 260ns(min.)
Row Active Time: 32.125ns(min.)
Maximum Operating Power: TBD W"
UL Rating: 94 V-0